http://lumberjocks.com/assets/pictures/members/282002-50x50.jpg
Getting things put together, Finally!! Sides have been “fixed”, front and back panels are done. Needed to drill some counter-bored pilot holes to assemble the sides to the front and back. Small forstner bit for a counter bore in the Drill press. Haul the slab of the front to the press, go to drill the first hole….table tilts! So, dig through the tool boxes, find the right sized wrench, and tilting table tilts no more. Got the front and backs drilled, time for some glue and screws
Here are the holes, about 3/8” diameter. Plugs will show up, later. Got the sides screwed to the front panel, and then added the rear panel
The long clamp on top is to pull the case square. Almost too big for the bench. Might as well sit this on the shop floor, and work on something else. Had a couple wide pine boards, cut them to the length to fit into the bottom of the chest. Already had 1
Tool chest or blanket chest? #4: Glue-ups!
No comments:
Post a Comment